PRODUCT FAMILIES
Evaporators for cabinets and small rooms
FRIMETAL evaporators are designed to satisfy all the requirements of today's refrigeration market.
Mini-vap unit coolers of minimum dimensions, specially height since they are primarily designed for commercial refrigerating cabinets or small cold storage rooms of low height.
Series
Fin Spacing
Application
MVP
4 mm
Refrigerating cabinets down to -18ºC.
MVG
4 mm
Refrigerating cabinets down to -18ºC.
MVM
4,2 mm
Small rooms with fresh goods at 0/+2ºC.
MVB
7 mm
Small rooms for preservation of frozen products down to -30ºC.
CHARACTERISTICS
- Casing in aluminium sheet coated in white polyester RAL-9002 resin. With hinged drip tray at the bottom and intermediate tray under the coil to allow the water drainage and to lodge the defrosting heaters.
- Galvanized steel brackets for anchoring to the ceiling.
- Axial single phase fan motors :
- Diameter 230mm (MVP, MVG, MVM and MVB): shaded pole type 230V 50/60Hz IP-42.
- Diameter 300mm (MVM and MVB): external rotor type 230V 50/60Hz, IP-44.
SPECIFIC OPTIONS OF THIS RANGE
- Electrical or hot gas defrosting.
- Circuits for water or other liquids.
- Stainless steel tubes (MVM y MVB).
- Pretreatred aluminium or stainless steel fins. (MVM y MVB).
- Completly Casing in stainless steel.
- Coated coil with polyurethane resin (consult the Technical Departmen of Frimetal).
- Adaptation to refrigerant CO2 o glycol.
DOWNLOAD CATALOGUE DOWNLOAD MANUAL